Waterproofing paint for motorhome caravan roofs

PLAS-T-COTE alkyd fiber ceiling cladding

for roof protection and
Aluminum outer skin, galvanized
Metal or fiberglass.
Especially for campers, caravans,
Minibuses and mobile homes. just
and apply quickly with a brush
or roller. Many uses,
great for sealing
leaking roofs, repairing
Hail damage, rockfall protection app.
white, high quality
Alkyd resin ceiling coating is
viscous, conforms to the surface
Exactly and guard against
all weather conditions. She stays
flexible, so that they are with him
Contracting roof seams and
expands. The coating has
excellent protection against noise and
Insulating properties. It forms
no stripes,
does not fade

This coating is suitable for all sheet metal, aluminum, galvanized metal, fiberglass and other hard surface roofs.
decide. Not to be applied to asphalt or rubber lined roofs as it will cause damage
Blisters may appear. Before application, all loose seams, rust and other debris must be removed.
Coating area with a wire brush to be removed. Similarly, all residues of grease, etc., with benzene or
Comparable solvents are removed. New galvanized roofs and aluminum roofs must be etched before coating
To achieve maximum responsibility. Apply only on dry roofs. The alkyd fiber ceiling protective coating.
It must be applied hot. To do this, place the can in a bucket of hot water before opening. The water temperature should be around 60 degrees Celsius and stir the paint to dilute in case of lumps. Before application
stir gently. With a soft brush or a thin roller and kurzhaarigen on the entire surface of the ceiling or also
Apply an even coat approximately 1mm (never more than 3mm) thick. All screw heads, seams.
and areas around vents, shafts, windows, or transitions must be completely covered. Through such alkyd fiber
Roof protection cladding will provide maximum weather protection with soundproofing and insulating properties for many years.
accomplished. Depending on weather conditions, fingertip-sized parts of the coating may peel off after at least 3 to 5 years.
Remove these and re-cover them. The old coating does not have to be removed.
Average consumption: 1 can (3.785 liters) is enough for about 4 square meters.
Drying time: 2 to 4 hours, depending on the weather at room temperatures of 20 ° C. If the thickness of the material is too high or too low
The temperature takes longer to dry the surface. Below the surface, the material remains wet, around the surface.
To ensure elasticity.
application:
Average consumption: 1 can
(3.78 liters) is enough for approximately 1.2 to
4 m2. Drying time: 2 to 4 hours,
depending on the weather
Technical data:
Alkyd, white, 3.78 l container,
4850g