VICTRON Energy SmartSolar MPPT 100/15 solar regulator for motorhomes and campers.

Model with Bluetooth.

VICTRON Smartsolar 100/15 charge controller with integrated Bluetooth
The Victron Energy Smartsolar 100/15 charge controller is a MPPT solar charge controller
with maximum charging current of 15 amps for charging 12 volt and 24 volt batteries.
Unlike the Bluesolar 100/15, the Smart version has integrated Bluetooth,
making the purchase of Bluetooth dongles unnecessary.
The integrated Bluetooth in the SmartSolar series is the wireless solution for configuration,
monitor and update the controller using Apple and Android smartphones,
tablets or other devices.
The most important technical features at a glance:

Maximum charging current 15A, suitable for 12V and 24V batteries.
Nominal photovoltaic power for 12 V systems: 220 W.
Nominal photovoltaic power for 24 V systems: 440 W.
15A charging output.
High maximum efficiency of 98%
Freely programmable battery charging algorithm (via free Victron Connect app)
Programmable dimming functions (via free Victron Connect app)
Ultra-fast maximum power point tracking
Maximum open circuit voltage of photovoltaic: 100 V
Charging algorithm: multi-stage, adaptive
built-in Bluetooth module
Ultra-fast maximum power point tracking
Especially when the sky is cloudy, when the intensity of the light is constantly changing,
An extremely fast MPPT controller improves energy efficiency compared to PWM charge controllers
up to 30% and compared to slower MPPT controllers up to 10%.
smart charging output
Deep battery discharge can be avoided by using 12/24 volts.
End users can connect to the charging output.
The charging output cuts off the 12/24 volts when the battery reaches a predetermined level
The voltage value has been discharged.
Alternatively, you can also choose an algorithm for intelligent battery management – see BatteryLife.
The load output is short-circuit resistant.
Battery life: Intelligent battery management
If the solar charge controller cannot charge the battery to its full capacity in one day,

The battery status constantly changes between "partially charged"

and “end of discharge” back and forth.
This mode of operation (without regular full charge) will damage a lead-acid battery.
within a few weeks or months.
The Battery-Life algorithm monitors the battery charge status and, if necessary,
raises the threshold for disconnecting the load day by day (i.e. the load is disconnected earlier),
until the energy obtained is sufficient to charge the battery to almost 100%.
From this point on, the load shutdown threshold is modulated,
so that almost 100% of the charge is achieved approximately once a week.
Scope of delivery:
1 Victron Energy Smartsolar MPPT 100/15 15 Amp 12 Volt/24 Volt Solar Charge Controller
1 user manual